D-Link Range Extenders > DAP-X1870

DAP-X2810 config page not working properly after firmware upgrade

(1/1)

guenter@gzoechbauer.com:
I have a D-Link DAP-X2810 AX1800. I couldn't find a better area to post this question. Please suggest where to post this if this is not the right place.

The device worked fine, but I had issues with DHCP over a range extender, so I looked for a firmware update and found
https://eu.dlink.com/rs/sr/products/dap-x2810-ax1800-wifi-6-dualband-poe-access-point#support
After the update some areas of the config page don't work anymore.

For example
Basic Settings/Wireless only shows an empty page.
The LAN and IPv6 pages look fine.
Advanced Settings/Performance only shows a red "Error:" and the "Save" button.
Advanced Settings/Wireless Resource shows 2 dropdowns with "Enable"/"Disable" to chose from (but no label) and again the "Error" and "Save" button.
Advanced Settings/Multi-SSID shows a loading spinner and again "Error" and "Save" button.
Advanced Settings/VLAN look fine.
The rest looks similar. Some pages look fine, some show partial content.

I tried to uploading the firmware update again and also a factory reset, but no change.

I can still connect to the network using this access point.

Any ideas how to fix the issue or go back to 1.0 firmware?

guenter@gzoechbauer.com:
I just came back to my computer and tried again after a few hours and now the config pages seem to work again.
So the issue seems to be solved.

MathildeBuxton:

--- Quote from: guenter@gzoechbauer.com on May 02, 2022, 04:31:20 AM ---I just came back to my computer and tried again after a few hours and now the config pages seem to work again.
So the issue seems to be solved.

--- End quote ---
  Great!

Navigation

[0] Message Index