D-Link Enterprise > DGS-1210-Series

DLINK DGS-1210-28P - VOICE VLAN

(1/1)

Joaodagraca:
Good day all,
I'm very new to VLANS and need to get this switch setup fairly quickly. Here are the requirements

VOICE VLAN ID =2
Only IPPhones will be plugged into ports 1 -22

port 23 has a management laptop plugged into it
port 24 is connected to port 2 on  the cisco router which links through to the service provider offering the PABX service

They have said that the Voice VLAN needs to be on ID 2 to be able to obtain DHCP addresses from the router.
How would I configure this?
Thanks in Advance :-\

PacketTracer:
Hi,

voice VLANs are only needed, if you connect phones that itself provide connectors for PCs - hence you would connect a combination of a PC and a phone to one switch port.

But since you say that only IP phones will be connected you can use a standard VLAN instead of a voice VLAN.


--- Quote ---They have said that the Voice VLAN needs to be on ID 2 to be able to obtain DHCP addresses from the router.
--- End quote ---

I interprete this statement to mean that Ethernet frames entering/leaving your router's port 2 have to be tagged with VID 2.

Hence, I'd suggest you configure your switch as follows:


* Add a new VLAN with VID=2.
* Ports 1-22: Set them to be untagged members of VLAN 2, set their PVID=2.
* Port 24: Set it to be a tagged member of VLAN 2, leave its PVID at its default value (1).
See this manual, page 32, chapters "VLAN > 802.1Q VLAN" and "VLAN > 802.1Q VLAN PVID".

PT

Navigation

[0] Message Index