• March 19, 2024, 01:02:53 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Motion detection activated snapshots taking never stops until rebooted  (Read 8998 times)

soaway

  • Level 1 Member
  • *
  • Posts: 1

Hello Everybody,

I was wondering if anybody came across and dealt with an issue when after lot's of motion detected camera keeps taking snaps every 30 sec indefinitely until camera is rebooted? it's not specific Firmware, upgraded few times.

Ideas?
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Motion detection activated snapshots taking never stops until rebooted
« Reply #1 on: September 20, 2016, 12:11:47 PM »

Link>Welcome!

  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

What Mfr and model is the main host router?
How is the camera connected? Wired or Wireless?
What wireless modes are you using?

Haven't seen other users with this issue...
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.