• November 21, 2017, 03:04:52 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS-933L: set motion detection area without Java?  (Read 662 times)

w9wi

  • Level 1 Member
  • *
  • Posts: 1
DCS-933L: set motion detection area without Java?
« on: January 07, 2017, 09:18:53 PM »

I can't figure out how to set the motion detection area.  I'm running Windows 10 which, it seems, has no support whatsoever for Java.  Which means when I'm prompted to "Detection Areas  Use mouse to click the blocks where you want to monitor for motion.  " -- there are no blocks to click. 

I'm wanting it to email me a set of images when motion is detected.  I would be good with the detection area being the entire frame.  Is there any way to accomplish this without Java? 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 43669
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology
Re: DCS-933L: set motion detection area without Java?
« Reply #1 on: January 09, 2017, 08:22:21 AM »

Link>Welcome!

  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

Try using IE11 or FF browsers with Java installed?
Logged
Cable:100mb/3Mb>Motorola SB6183>COVR3902>HP 24pt Gb Switch. 3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,865L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting