• October 22, 2017, 02:10:30 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Access to webadmin to flip image?  (Read 1540 times)

thechilibuddy

  • Level 1 Member
  • *
  • Posts: 1
Access to webadmin to flip image?
« on: November 27, 2015, 04:32:46 AM »

Hi, all I'm trying to do is to get the damned camera to flip the image since the camera is mounted up against the ceiling so I'm seeing an inverted picture. I've tried to access the webadmin page to get to "Image Setup" but there is no option for that under setup.

So, the only page I seem to be able to access on webadmin is eng/mainFrame.cgi?nav=Setup#

Does anyone have any ideas how I can flip the image or get to a page where I can check that box off? We've got other Dlink cameras and even those have access to advance setting on drink cloud and allows me to flip image.

I've done it before... but I can't for the life of me figure out how I did it the first time... we moved and now I'm stuck again.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 43412
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology
Re: Access to webadmin to flip image?
« Reply #1 on: December 01, 2015, 06:40:10 AM »

Is there any information in the user manual about this?  ???
Logged
Cable:100mb/3Mb>Motorola SB6183>DIR-880L>HP 24pt Gb Switch. 3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,865L,836L,826L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L and a Boxee.
Go Here>Router Troubleshooting

rafaecu

  • Level 1 Member
  • *
  • Posts: 1
Re: Access to webadmin to flip image?
« Reply #2 on: September 09, 2016, 07:10:14 PM »

hi thechilibuddy did you find any way to flip the image on DCS 825L? i have the same problem
Logged

RYAT3

  • Level 10 Member
  • *****
  • Posts: 2075
Re: Access to webadmin to flip image?
« Reply #3 on: September 09, 2016, 07:18:54 PM »

Logged

JJdaCool

  • Level 1 Member
  • *
  • Posts: 15
  • I be the JJdaCool
Re: Access to webadmin to flip image?
« Reply #4 on: April 09, 2017, 04:05:57 AM »

If you are still having and issue try the webpage below to rotate image 180 degrees (Replace ipaddr with your camera's ip address) login with username admin and the password you set on the camera

http://ipaddr/config/sensor.cgi?flip=on&mirror=on
 
check
http://ipaddr/config/sensor.cgi
 should say flip on and mirror on.

to go back to normal zero degrees try
http://ipaddr/config/sensor.cgi?flip=off&mirror=off

Logged
Yo!