• March 28, 2024, 10:21:39 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Pages: 1 [2] 3 4

Author Topic: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems  (Read 31444 times)

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #15 on: December 13, 2016, 07:32:56 PM »

Yes, I did.
Logged

RYAT3

  • Level 10 Member
  • *****
  • Posts: 2254
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #16 on: December 13, 2016, 10:18:16 PM »

Yeah I'm out of ideas at this point...

Other than swapping working cams w/ this one and observing further results...

It sounds like something is going on with this area for whatever reason...

Logged

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #17 on: December 14, 2016, 08:56:50 AM »

That's what I think I am going to do......   
This time, I'll buy the service plan with my new camera! 

I wonder if  a near by motion sensor light or gutter heating cable would influence the camera, even though it is hard wired?   

Oh, no, I see another one of my cameras is acting up, now.  The one that was in this problem area!


If I figure out the problem, I'll post it, just so you know.   Thanks for your help!! 
Logged

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #18 on: December 18, 2016, 02:04:32 PM »

Still no success, the camera failed outside.  It only works in the house.  So, I sent in a request for service/replacement.
Another camera is doing the same thing at my office. 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #19 on: December 19, 2016, 07:07:19 AM »

You might phone connect D-Link support and ask for higher level escalated support and see if you an talk to someone about this issue. seems like the cameras are not working well out side however they do inside a building.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #20 on: December 19, 2016, 08:26:51 AM »

I know this will sound bad.  But, compared to the last time I spoke with them, you guys are smarter!   I am going to return this camera under the warranty, along with another one, or two. 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #21 on: December 19, 2016, 08:28:58 AM »

Let us know if the same thing happens with the newer units...
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #22 on: December 19, 2016, 08:36:40 AM »

I will.  This camera, is only 4 months old, it replaced the 1st problem camera.   I have 7 of these cameras set up with the same PoE injector, network switches, and network, at two locations (I shoot a signal to my office, from my house) and I am getting close to a 50% failure rate!   I have 21 other D-Link cameras which are working ok.  I also have a DCS-942L (an indoor camera) with similar problems. 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #23 on: January 24, 2017, 07:15:31 AM »

Any status on this?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #24 on: January 24, 2017, 07:26:43 AM »

Yes, I sent it back for replacement.  They sent me a refurbished unit that was worse!!!   Now, I am waiting for another replacement. 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #25 on: January 24, 2017, 07:29:50 AM »

Can you test the 2310L with out using a POE injector to see if you find a difference in behavior?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #26 on: January 24, 2017, 08:11:18 AM »

I tried with and without the PoE injector.  No success either way.  This was in the comfort of my house.

I have an older camera with the same problem, but it works with the power supply, until the temperature goes below 20 degrees, then it stops working, until I restart it.  This one is past the warranty period, so I can't return it.   :( 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #27 on: January 24, 2017, 08:33:32 AM »

Let us know how the next replacement goes. This may need some higher level support.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

Brian6962

  • Level 2 Member
  • **
  • Posts: 28
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #28 on: January 24, 2017, 08:47:39 AM »

I will. 

I talked to tech support each time I have a problem.  No one says this is a common problem with this camera.  But I've had 4 out of 7 cameras with problems!  None of my other models have had problems. 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-2310L with TP Link gigabit ethernet POE injector p r oblems
« Reply #29 on: January 24, 2017, 08:54:36 AM »

There a case number for this?

Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.
Pages: 1 [2] 3 4