D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-826L => Topic started by: LynnField1366 on March 14, 2017, 09:58:40 PM

Title: Could D-Link add IPv6 Passthrough mode to DIR-836L?
Post by: LynnField1366 on March 14, 2017, 09:58:40 PM

Could D-Link add IPv6 Passthrough mode to DIR-836L's firmware?
I've tried several routers and found that only in Passthrough mode I can get ipv6 address and visit ipv6 websites.

Or anyone has any other way to help with my case?

Title: Re: Could D-Link add IPv6 Passthrough mode to DIR-836L?
Post by: FurryNutz on March 15, 2017, 11:39:44 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

How do you have the router configured? There is a a drop down for Automatic and Local Only. I think if you use local only with out any other configurations, IPv6 should pass thru. Not sure however.

FYI:
    This product has been discontinued.
    Free support for this product will end on 11/01/2017

You can use this as as LAN to LAN AP then anything will pass-thru: Turning a router into an AP. (http://forums.dlink.com/index.php?topic=40856.0)