Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[PatiS]

Setup:
PFSENSE (WAN)= 125.5.78.228 (GW) = 125.5.78.227
DLINK ROUTER (WAN)= 202.175.233.250 (GW) = 202.175.233.249

(PFSENSE)
For Phase1
Remote Gateway: 202.175.233.250
My Identifier: 125.5.78.228
Peer Identifier: 202.175.233.250
Proposal (Authentication)
Key Exchange protocol: IKEv2
Authentication Method: Mutual PSK
Negotiation Mode: Main
Pre-shared Key: 12345678
(Encryption Algorithm)
Encryption: AES 256
Hash: SHA384
DH Group: 15(3072)
Lifetime(Seconds):10800
Dead Peer Detection: ON

Phase 2
Mode: Tunnel IPV4
Local Network: 192.168.1.0/24
NAT: N/A
Remote Network: 192.168.2.0/24
Protocol: ESP
Encryption Algorithm: AES 256
Hash Algorithm: SHA384
Lifetime: 10800
PFS Key Group: off

And for the
DLINK DSR-1000 router
I also put desame parameters.

And the Error that getting from DLINK logs is:
"Racoon 1922- -phase 1 negotiation failed due to time up for 125.5.78.228(500)"
"Racoon 1922- -invalid SA protocol type:0"
"Racoon 1922- -phase 2 negotiation failed due to time up waiting for phase1."

If anyone here have an idea about this please help. Will appreciate it very much.

[FurryNutz]

Welcome!

I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this.
Link> Tech Support Contact Information
We find that phone contact has better immediate results over using email.