D-Link Forums
D-Link FAQ => Network Camera FAQs => Topic started by: JavaLawyer on April 13, 2012, 11:41:39 AM
-
This procedure describes the steps required to reset a D-Link network camera to the factory default settings.
Procedure
While the D-Link network camera is powered-up, use a paper clip to press and hold the recessed reset button on the rear of the camera for > 8 seconds. This procedure will erase all user and configuration settings, but will not remove the currently installed firmware version.
Notes
- The Reset Button location may vary on different D-Link network camera models. Please refer to the D-Link network camera user manual to determine the Reset Button location for a specific D-Link network camera model.
- Creating a Configuration Settings file prior to performing this procedure will enable you to quickly restore all user settings.
Additional Resources
- DCS Network Cameras - Configuration Settings File (http://forums.dlink.com/index.php?topic=48125.0)
- Network Cameras - Searchable FAQ Index (http://forums.dlink.com/index.php?topic=58404.0)
- Network Cameras - Important Posts & Information (http://forums.dlink.com/index.php?topic=58121.0)