Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[ksgupta1991]

i have a dlink adsl router(dsl 2750U) and a D-Link DIR-600L Wireless N150 Cloud Router.
when i connect the adsl router to the cloud router from adsl lan to 600l wan using the 1.5m cable the adsl router allocates the ip to the cloud router.
but when i connect using the 30 meters cable the cloud router is not getting the ip address form the adsl router.
i checked the cable by connecting my laptop to adsl router by the 30m cable(both in cross and straight mode),its working fine.

but when i used the 30m cable in(straight and cross mode)the cloud router is not getting ip from the adsl router.
adsl config:192.168.1.1  dhcp enabled.
cloud config:192.168.2.1  dhcp enabled.

any suggestions would be helpful?

[FurryNutz]

Link>

Welcome!

• Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended.

Also:
li] If this modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems: Link>Double NAT and How NAT Works. To tell if the modem is bridged or not, look at the routers web page, Status/Device Info/Wan Section, if there is a 192.168.0.# address in the WAN IP address field, then the modem is not bridged. If the modem can't be bridged then see if the modem has a DMZ option and input the IP address the router gets from the modem and put that into the modems DMZ.[/li]
[li]For DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.[/li][/list]

[ksgupta1991]

i used a cat 6 cable in both (standard and cross modes).
both the 1.5m and the 30m cables are working fine.

but when i use the 30m cat6(standard or crossed)cable, adsl router is not giving ip to 600l router.
(the links between both the routers are also stable).

[FurryNutz]

Well if the shorter cable is working and the longer cable isn't, I would presume the longer cable could be at fault here. Are you powering OFF the 600L before installing the longer cable? Try different ports on the back of the 600L?

[ksgupta1991]

i tested the long cable using the network cable tester and its working fine.
i installed the long cable between adsl router and the 600l router in different possible cases(ie adsl router "on" and 600l "off" ,adsl "on" and 600l "on" )
but its not working.

[FurryNutz]

So can you install the longer cable and put in place a Laptop or PC and test instead of the 600?

[FurryNutz]

Also pull the cable in and re-seat on both plug ends