• April 19, 2024, 09:00:57 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Will this page would not self populate everytime it accessed in dlink 2750u  (Read 2211 times)

jraju

  • Level 2 Member
  • **
  • Posts: 31
Will this page would not self populate everytime it accessed in dlink 2750u
« on: September 03, 2021, 09:47:04 PM »
Hi, When I was using the dsl dlilnk 2730u wifi router, this page was self pupulating one, giving you useful information of attainable dwnload and upload stream from time to time on the log on. the page has a start button also
Now, I upgraded to dsl dlink 2750 u hw w1 and fware 1.01 version. It gives the result , when you click the start button, but became blank on next reboot in all the columns. here also i have the start button. but i have to manually click to get it populated . Any settings idea to be enabled to self populate
https://ibb.co/Kyw0w9P
Logged

jraju

  • Level 2 Member
  • **
  • Posts: 31
Re: Will this page would not self populate everytime it accessed in dlink 2750u
« Reply #1 on: September 06, 2021, 11:44:03 PM »
Hi for clarity, I enclose a picture of the page, that I am askinghttps://ibb.co/fksx8b7
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Will this page would not self populate everytime it accessed in dlink 2750u
« Reply #2 on: September 07, 2021, 01:17:49 PM »
Has a factory reset and setup from scratch been performed since the FW was updated?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

jraju

  • Level 2 Member
  • **
  • Posts: 31
Re: Will this page would not self populate everytime it accessed in dlink 2750u
« Reply #3 on: September 07, 2021, 11:48:28 PM »
Hi, Furry,
Yes , I did , will do it again. Please say, that will it populate itself? or should we click the button to check to populate.
I ask this specific query, because, when I used the 2730u, it was self populating and I could always see the attainable download and upload speed in here at the top of the page.
My version of dlink router is 2750u h/w ver:w1 and software 1.01 version manufactured in 2020.
there is no update available for this version.
Logged