D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: ketchoupi on December 17, 2013, 01:23:36 PM
-
hi
i'm using a dcs-932l since one day.
my english isn't very good but i'm tring to explain what i want
i've a question about motion detection :
is it possible to change status of motion detection via http in local network?
ex: http://IPcam:port/set_alarm.cgi?motion_armed=0 &user=user&pwd=password
http://IPcam:port/set_alarm.cgi?motion_armed=1 &user=user&pwd=password'
thanks for your attention
edit: http://user:pwd:80/config/motion.cgi?enable=yes not good to .....
-
i think it's almost
http://IPADRESS/motion.cgi?user=XXXXXX&password=XXXXXX
MotionDetectionEnable=1
MotionDetectionBlockSet=0000000000000000000000000
MotionDetectionSensitivity=20
someone else want to try?
source :http://www.ispyconnect.com/man.aspx?n=D-Link
-
Did you find the answer? I personally search this functionality and didn't find yet for my DCS-933L!