D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-5010L => Topic started by: soaway on September 20, 2016, 10:46:40 AM

Title: Motion detection activated snapshots taking never stops until rebooted
Post by: soaway on September 20, 2016, 10:46:40 AM

Hello Everybody,

I was wondering if anybody came across and dealt with an issue when after lot's of motion detected camera keeps taking snaps every 30 sec indefinitely until camera is rebooted? it's not specific Firmware, upgraded few times.

Ideas?

Title: Re: Motion detection activated snapshots taking never stops until rebooted
Post by: FurryNutz on September 20, 2016, 12:11:47 PM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What Hardware version is your DCS? Look at the sticker behind or under the camera.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DCSs web page under status.
• What region are you located?

What Mfr and model is the main host router?
How is the camera connected? Wired or Wireless?
What wireless modes are you using?

Haven't seen other users with this issue...