D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => WBR-1310 => Topic started by: eracet on August 25, 2010, 02:25:45 PM

Title: DCM 202 configuration
Post by: eracet on August 25, 2010, 02:25:45 PM
I am sorry for posting here but it looked like the closest area to post since there is not a section for This model. If there is an area to post please let me know.

To the problem at hand. I have had this for a few years, love the router. I have it connected to a network switch that connects to my home PCs and adapters.

Here is the problem. I recently brought an item called Pogoplug ( a Media Sharing device).
This connects to pogoplugs servers. The problem is it uses a port that is getting blocked by the router( as far as I know) I did call the ISP they say that isnt blocked on there end.
This is after connecting directly to the router with nothing else attached.

Requirements I need are DHCP enabled.
UDP port unfiltered.

I went into settings VIA browser and it doesnt show any available configuration except for a password change.

Is there any ways to check for settings on the router or change anything?
Title: Re: DCM 202 configuration
Post by: !!!!clarkkent on August 25, 2010, 06:53:32 PM
You are using DCM-202? It ain't a router. It's a modem. It doesn't block anything.
Title: Re: DCM 202 configuration
Post by: eracet on August 25, 2010, 07:16:10 PM
yes I realized this after I did some research. thank you.
My mistake.

can Delete topic when possible
Title: Re: DCM 202 configuration
Post by: !!!!clarkkent on August 25, 2010, 07:22:01 PM
No harm done. post anytime if you need recommendations.