• April 13, 2021, 04:49:31 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DFL-210 Can't remote into network  (Read 4400 times)

krhoover

  • Level 1 Member
  • *
  • Posts: 7
DFL-210 Can't remote into network
« on: April 02, 2017, 12:16:43 PM »

I am trying to configure a DFL-210 to allow for rdp access to a certain computer on the network. All internal routing is done through a managed switch (HP-2920) that handles several VLANs. Every configuration I have tried gives the error that the "computer can't be found on the network". I know I have Remote Desktop set up correctly on the target computer, but I can't figure out how to access it from outside the firewall.  I could use any help I can get, as I am not familiar with programing firewalls. I don't know how to attach a file to this thread, but can send if if I know where.

Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49572
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DFL-210 Can't remote into network
« Reply #1 on: April 07, 2017, 07:02:46 AM »

Any status on this?

I presume RDP would be using something like ##.##.###.###:RDP Port#. The IP address being the Public/WAN IP address of the MODEM or Router that your network is connected too.
Logged
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.