D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNR-202L => Topic started by: Kietl on March 04, 2014, 11:36:02 AM
-
Is there any instruction, procedure i should follow to add new camera and replace hard drive?
Regards,
-
If you don't care about losing the recording that you already have, then you can just plug the new hard drive in and unplug the old one. The only concern with hard drives (I think) is whether or not they're formatted correctly. The 1TB drive I'm using didn't require any special process.
With the new camera set up on your network, I believe all you need to do is go to the Setup - Add Camera page in the DNR-202L's direct IP interface, select the camera and enter the username and password.
If you would like the camera to send motion-detection events to the DNR-202L, then you'll need to set up motion detection in the camera's settings first, then turn on receipt of motion detection events in the DNR-202L's Setup - Event Setup page. (For recording motion detection events only, or for highlighting motion events on the continuous recorded stream.)
-
Enter the IP address of the DNR-202L in a browser on a PC connected to the same LAN as the device. Once logged into the web UI, you will find options to add additional cameras, configure the network setup, as well as other settings.
-
Thank you.
-
Post back if you have any specific questions! ;)