D-Link Forums
The Graveyard - Products No Longer Supported => Other D-Link Products => DSP-W215 => Topic started by: JavaLawyer on May 12, 2014, 11:39:49 AM
-
This procedure describes the steps required to reset a DSP-W215 Smart Plug to the factory default settings.
Procedure
While the D-Link DSP-W215 Smart Plug is powered-up, press hold hold the WPS/Reset button on the side of the device for greater than 10 seconds. This procedure will erase all user and configuration settings, but will not remove the currently installed firmware version.