Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[abjt]

I have Dlink DIR600 router, I wanted to use it as Repeater to extend my Wifi range, so I flashed DD-WRT as DIR600 does not have this functionality
After flash I could use DD-WRT firmware page to setup to use it as repeater however there was no internet hence I flashed it again but now when try to login to firmware page using IP 192.168.1.1 I am not getting it displayed correctly it is showing few dots vertically then three boxes which I think are username, password then change password button. there are no labels nothing.
I tried giving new password then change password button but nothing happens.
Please let me know how to bring back the original DIR600 firmware


Please help
Thank you

[FurryNutz]

Please refer to the DD-WRT web site for help and information regarding there FW.

[abjt]

Thank you for quick reply.

Is there a way to get back to original dir600 FW using any method?

[FurryNutz]

Try this:
Emergency Recovery Mode

[abjt]

Thanks a lot. I am able to restore the original DIR600 firmware after following the instructions given in the link.

Now I have another question - is it possible to use this DIR-600 router as repeater to extend my wifi range, if yes, could you please guide me how to do it? or point me to a link for reference. I tried searching for DIR-600 but could not find it.

Thanks in advance.

[GreenBay42]

I do not believe the DIR-600 has repeater functionality. Looking through a couple manuals it does not look like there are any non-router functions.

[FurryNutz]

The 600 doesn't support repeater or extender mode.