The Graveyard - Products No Longer Supported > DIR-859

Advanced >> Firewall Settings >> IPv4 Rules dont block flood from external Ip

<< < (3/3)

FurryNutz:
Set a schedule for these two settings and highlight ALL sections in the time frames. Save and apply.

userdsp:
So i do mistake with IP adress and ill correct it.
I make this time frame correction too and i can still ping this IP :(

GreenBay42:
Reset the router (paperclip in the reset hole for 10 seconds with the router powered on) and reconfigure from scratch.

The rules are not doing anything. The traffic will still hit the router.

You can try to router the traffic to a false IP.  Go to Features > Firewall > IPv4 Rules

Source - WAN 74.125.153.250   ( do not add anything else, just the IP address)

Destination - LAN  Enter an unused IP address on your local network (192.168.0.2 for example)

Protocol/Port - Select ANY.

Make sure Turn IPv4 Filtering ON and DENY rules listed is selected.

But again the traffic is still coming in so there is something going on.

userdsp:
Do not work
Destination - LAN  Enter an unused IP address on your local network (192.168.0.2 for example)
Why to block connection to unused IP? I make it and dont work. Then i change it to my internal ip and still do not work.

GreenBay42:
Is the traffic trying to go to a particular IP address on your network?

Did you reset the router?

The rules block the traffic from entering your network, it does not prevent the flood.

Navigation

[0] Message Index

[*] Previous page