D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: Rodent on December 18, 2007, 03:04:34 PM
-
Hi,
I have a problem will the two new HDDs I placed into the DNS-323, one of the HDDs was DOA but I did not know this and the unit did not tell me (I have been over this in another post) but the unit did power down the drives as I would have liked, since I have replaced the faulty HDD reformatted the drives as RAID 1 the drives have not been powering down and the temperature is currently about 48 C (very hot). I do not have anything plugged into the USB port.
Power Management is Enable and set to 10 minutes, I have tried turning off power management and than turning it back on but still not working. This is a very important part of this device and I need it to work as summer is just about here and the temperature is going up.
I have not tried resetting the firmware back to factory default, does anyone think this mite work?
Firmware Version 1.03
Two WD Carviar 500 GB SATAII Disks
Plugged into a gig switch
Any I dears
Rodney
-
I'd just like to bump this up to the top as I too have this same issue. However, I have tried reverting to factory settings, and it still does not go into power save...
Thoughts?
Thanks!
-
In the last week the HDD's have been powering down and this function seems to be working fine now, I have not changed any settings at all but the temperature has dropped down to about 36 C when not in use and the device takes about 10 - 20 seconds to access the data while the drives are powering up so for now I'm happy... ;D
Thanks
Rodney