D-Link VPN Router > DSR-500N

0dbM WiFi Transmit Power

(1/1)

GlennXS:
I have a DSR-500N that reports no/0 transmit power; however i setup the transmit power value.  The reason i'm concerned is because various client devices in close proximity cannot see any AP broadcast as configured on this DSR-500N; however i setup its profiles/APs.  -Is it fair to say that the radio of this DSR-500N is broke?  That is, is there a test configuration that i could implement that should work regardless/every time?
 

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
Even after a factory reset of the DSR?

Navigation

[0] Message Index