D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-645 => Topic started by: arlesterc on May 10, 2020, 03:30:06 AM
-
Howdy. I have a Dlink Dir645. If I change port forwarding rules or enable UPNP, do I have to reboot the unit? What config changes require a reboot? Thanks in advance.
-
Most router changes will require a reboot. Only things that may not reboot is items under Administration.
-
Thanks. However if that is the case why does it not say that/warn when you make the change? The fact is the popup says the changes have been applied. Do you have any link or reference from Dlink that confirms a reboot is required? I couldn't find anything in the docs or Googling.
Thanks in advance for any further attention to this.
-
Possible it may not. Been a while since a used PF on the 645. I only use mine for emergency power outage wifi router.
If it doesn't appear after making changes, you can always manually reboot the router yourself then continue.
-
It is not documented anywhere but most routers, not all, require a reboot for the settings to take effect, especially with any kind of rule creation such as port forwarding.