• March 20, 2018, 10:36:19 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Could D-Link add IPv6 Passthrough mode to DIR-836L?  (Read 1838 times)


  • Level 1 Member
  • *
  • Posts: 2
Could D-Link add IPv6 Passthrough mode to DIR-836L?
« on: March 14, 2017, 09:58:40 PM »

Could D-Link add IPv6 Passthrough mode to DIR-836L's firmware?
I've tried several routers and found that only in Passthrough mode I can get ipv6 address and visit ipv6 websites.

Or anyone has any other way to help with my case?


  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 44731
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology
Re: Could D-Link add IPv6 Passthrough mode to DIR-836L?
« Reply #1 on: March 15, 2017, 11:39:44 AM »


  • What Hardware version is your router? Look at sticker under the router case.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?

How do you have the router configured? There is a a drop down for Automatic and Local Only. I think if you use local only with out any other configurations, IPv6 should pass thru. Not sure however.

    This product has been discontinued.
    Free support for this product will end on 11/01/2017

You can use this as as LAN to LAN AP then anything will pass-thru: Turning a router into an AP.
Cable:200mb/10Mb>Motorola MB7420>COVR3902>HP 24pt Gb Switch. 3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,865L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting