D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4100 => Topic started by: themack on May 14, 2008, 09:09:50 PM

Title: No other computers shown when browsing network
Post by: themack on May 14, 2008, 09:09:50 PM

I recently swapped out a netgear with a DGL-4100 to handle the wired machines on my network. Everything has been working great except that none of the other machines show up when browsing the network on either the PC's, Macs or NAS. I can connect to the machines directly and I know they are all on the same workgroup and subnet. I was able to browse the network with the netgear just fine before swapping it out. I am using firmware 1.7, however I did try 1.8 just to check.

I figure there is just some setting I am overlooking, any suggestions?

 

Title: Re: No other computers shown when browsing network
Post by: Mlachake on May 15, 2008, 05:56:57 PM

Please try to recreate your network again while connected to the DGL-4100. That should solve the problem.

Title: Re: No other computers shown when browsing network
Post by: themack on May 15, 2008, 07:03:24 PM

That worked! Thanks so much for the fast reply!

Title: Re: No other computers shown when browsing network
Post by: Mlachake on May 16, 2008, 09:35:20 AM

You are most welcome.