D-Link Forums
The Graveyard - Products No Longer Supported => Hubs and Switches => DGS-1224T => Topic started by: boxer on December 18, 2009, 11:12:28 PM
-
hi sir
in our network around 46 switches (D-link) 1224T are places that had no Ip address assign them i.e they are running in default configuration mode
when i reset one of switch , by mistake ip assign to the switch was Ip address of my one of my server
so the there is conflict message in my window server i just repair the connection of my server
every thing get fine but after 15-20 min it pop up the message Ip conflict again !!!
after that I reset the switch IP (So switch was again in default mode )
and repair the connection of server again it again get work but after around 40 min it again pop up message of Ip conflict and just shutdown the switch and when we trace out it was the mac address of the another switch that is attaches to the network but i cannot understand how the Ip address of one switch get assign to the other switch and also change password that switch was in another department after manually accessing the switch and seeing the switch mac address it take around 6 hr :(
i had google also yahoo :) also get chat with network administrator but not find any solution
switch are in cascading
how switch had got the Ip address of another switch and how to trace the switch any software
any other way to prevent Ip conflict message so that switch not get Ip of any server
any help
-
These switches will use the IP of 192.168.0.1/24 by default. They should not be placed in a production network until they are safely at their correct IP. If your server sits at 192.168.0.1/24 then you will need to ensure these switches are configured before placing them into your network.
-
Thanks for reply but need to know how the IP of another switch get changed
-
Well if your switches are on their default config then I would expect you are going to have to individually assign them IPs and then return then to your network until they have all be rectified.