• March 28, 2024, 10:35:01 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Losing connection between two DAP-2590 APs  (Read 14914 times)

mikuglia

  • Level 1 Member
  • *
  • Posts: 3
Losing connection between two DAP-2590 APs
« on: April 18, 2013, 09:46:29 AM »

Hello to everyone, first of all I apologize for my bad English.

I've got a huge problem with two DAP-2590 APs, both of them are connected using WDS technology.

The APs are distant ~500 meters each other, so we are using two Antennas from TP-Link (model: TL-ANT5830B). The antennas are both connected with one cable on one connector of the Access Point, which is exactly the middle one.

The other two connectors are empty, because no antennas is connected on them, due to the fact they would be useless because we need long-range antennas. So that's why we chose to use the two TP-Link antennas.

However, the problem is that the connection isn't stable. We setup the WDS, everything looks fine until the connection, after some minutes of working well, it start to lag (increasing ping responses) and then they disconnect. After disconnecting, they can't see both each other anymore from "WDS Status", but after a while, they appear again and the connection comes up again between them.
And this happens over and over.

We also tried to change different settings, like channels, bandwidth, etc. But nothing solves the problem.

We upgraded the firmware to the latest version, which is the 1.25 according to the D-Link ftp.

What can cause this problem?

Could it be because of the DAP-2590 load balancing properties, so if the two main antennas doesn't have a good signal strenght, it switches to the other two antennas (which are empty) and then it loses the connection? (if it even has some function like this.)

Could it be also because of some interferences between the two APs? I get lots of PHY errors (500+ errors per refresh).

Thanks.
« Last Edit: April 19, 2013, 12:31:01 AM by mikuglia »
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Losing connection between two DAP-2590 APs
« Reply #1 on: April 18, 2013, 01:15:05 PM »

Link>Welcome!
What Hardware version is your DAPs? Look at sticker under the DAP.
Link>What Firmware version is currently loaded? Found on DAPs web page under status.
What region are you located?

Has a Factory Reset been performed?

What wireless modes are you using?
Try single mode G or N or mixed G and N?
Any cordless house phones?
Any other WiFi routers in the area? Link> Use InSSIDer to find out. How many?

Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

mikuglia

  • Level 1 Member
  • *
  • Posts: 3
Re: Losing connection between two DAP-2590 APs
« Reply #2 on: April 19, 2013, 12:29:37 AM »

Link>Welcome!
What Hardware version is your DAPs? Look at sticker under the DAP.
Link>What Firmware version is currently loaded? Found on DAPs web page under status.
What region are you located?

Has a Factory Reset been performed?

What wireless modes are you using?
Try single mode G or N or mixed G and N?
Any cordless house phones?
Any other WiFi routers in the area? Link> Use InSSIDer to find out. How many?



>What Hardware version is your DAPs? Look at sticker under the DAP.

A2

>What version is currently loaded? Found on DAPs web page under status.

1.25

>What region are you located?

Europe, Italy.

>Has a Factory Reset been performed?

Yes. Multiple times.

>What wireless modes are you using?

I've tried Mixed A/N, only N, only A.

>Any cordless house phones?

No.

Any other WiFi routers in the area?

Not much.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Losing connection between two DAP-2590 APs
« Reply #3 on: April 19, 2013, 07:26:21 AM »

Channel Width set for Auto 20/40Mhz or try 20Mhz only.
Try setting a manual channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear.
What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

mikuglia

  • Level 1 Member
  • *
  • Posts: 3
Re: Losing connection between two DAP-2590 APs
« Reply #4 on: April 19, 2013, 10:17:35 AM »

Channel Width set for Auto 20/40Mhz or try 20Mhz only.
Try setting a manual channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear.
What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto.

Before making this thread, I already tried everything you said.

>Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto.

If you read again the thread, you'll understand that there is no client who connects to the APs, because it's a bridge between the two APs. So that doesn't matter.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Losing connection between two DAP-2590 APs
« Reply #5 on: April 19, 2013, 12:12:53 PM »

I'm going to recommend that you phone contact your regional local DLink support office and ask for level 2 or higher support.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.