I got a DCS 2132L network camera, and would like to connect my Liftmaster garage-port opener to the DI/DO port. Then I could open my garage-port from my mobile-phone from the network camera app. I have IP Cam Viewer on my phone and the app has this button to open garage-ports.
The garage-port opener (Liftmaster) has two-wire with a button. So I need to have the camera to short-cut this two wires to open the garage-port.
But I have read the wiring-scheme in the manual, and can not figure out how I can wire this.
Can anyone explain this for me?
1. Digital Out (DO)
2. Digital In (DI)
3. DC5Volt OUTPUT
4. GND
I know this is possible with DCS-5222L because one on this forum has done this, but the DI/DO port is not wired like the DCS-2132L port.
By the way, I have two more of this camera's, and can anyone tell my what value of the resistor I must
use if I want to connect alarm and magnet-switch the way it shows in the wiring-scheme in the DCS-2132L manual?
I want to use one of the other cameras for another project.
![Smiley :)](http://forums.dlink.com/Smileys/default/smiley.gif)