D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-865L => Topic started by: GregHudson on December 12, 2013, 07:55:46 PM
-
G'Day.
I initially had similar problems with the 865L until I tried this...
Hard wired the 865 directly to my PC, and connected using the usual 192.168.0.1 address.
Then in the Network setup screen...
Router section: switched ON the DNS relay (so it gets the IP address from my cable modem once connected)
I manually set the 865 IP address to 192.168.0.101 (outside the usual range of addresses)
Next, I DISABLED the DHCP server (eliminating the double NAT issue)
Disconnected from the PC, and connected it to the Cable Modem.
Everything is OK now (except I can't register with mydlink)
Regards, Greg.
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=41537.0)
- What Hardware version is your router? Look at sticker under router.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
- What region are you located?
Internet Service Provider and Modem Configurations
- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?
- What ISP Modem service link speeds UP and Down do you have?
Did you register with mydlink.com with a account first then register the router. The router may sill be in a double NAT condition and might not work correctly due to your ISP modem. Let us know what model modem you have please.
-
Any status on this? ???