D-Link Enterprise > DGS-1210-Series

DGS-1210-28P: Vlan configuration in CLI

(1/1)

AlfredKOBA:
Hello,
please it's possible to configure the vlans in D-link switch?
I can't manage the switch in Web interface but i can ping it.
below the details i have in Telnet

DGS-1210-28P> ?
USEREXEC commands :
  config account admin password <passwd>
  config ipif System { ipaddress <ip-address> <subnet-mask> gateway <gw-address>
 | dhcp | bootp}
  config ipif System { ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client {enabl
e | disable}}
  debug info
  download { firmware_fromTFTP | cfg_fromTFTP} {<ipaddr>|<ipv6addr>} <path_filen
ame>
  logout
  ping <ip_addr>
  ping6 <ipv6addr>
  reboot
  reset config
  save
  show ipif
  show switch
  upload { firmware_toTFTP | cfg_toTFTP} {<ipaddr>|<ipv6addr>} <path_filename>
DGS-1210-28P>

Need your quick reponse.

Thanks.

FurryNutz:
Any progress on this?  :-\

Navigation

[0] Message Index