Topic: DGS-1210-48 Ports aggregation/separation (Read 8658 times)

andrey.mihaylov · « **on:** June 16, 2016, 12:56:21 AM »

Hey guys,

First at all i would like to apologize if my question is too dumb...

I want to separate aggregate switch by two, for example i used all 48 ports like Untagged VLAN Ports by default configuration, but i need to use port 33,34,35 and 36 in separated vlan again untaged , the reason that i want to do that is because i have 2 dhcp servers for different network and i dont want they are "talk" between. The most obvious way to do this is through a different(separated) switch and physically aggregation, but if its possible to be use only one will be the best .

Best Regards, and appreciate any help

FurryNutz · « **Reply #1 on:** September 16, 2016, 08:28:00 AM »

Any status on this ?

D-Link Forums

News:

Author Topic: DGS-1210-48 Ports aggregation/separation (Read 8658 times)

andrey.mihaylov

DGS-1210-48 Ports aggregation/separation

FurryNutz

Re: DGS-1210-48 Ports aggregation/separation