D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: wjburl on June 05, 2012, 05:55:21 AM

Title: IP Address Changed After Powerup
Post by: wjburl on June 05, 2012, 05:55:21 AM

I have two DCS-932L cameras.  One time on each camera, the IP address changed when I unplugged it to move it to another location.  It doesn't happen all the time.   I have to go through the installation procedure again to determine the new address.

Title: Re: IP Address Changed After Powerup
Post by: wjburl on June 05, 2012, 10:44:52 AM

bimo,  Thanks for the help.  I made the changes.  I hope I did them correctly.  The software sees the camera at the addresses using.  xxx.xxx.xxx.5 and xxx.xxx.xxx.6, except mydlink.com says the cameras are offline.

Title: Re: IP Address Changed After Powerup
Post by: wjburl on June 05, 2012, 11:53:31 AM

I did all reboots suggested, but it didn't work.  I finally use the installation disk and ran through setup wizard again, but keeping the changes I had made earlier.  At the end, there is a mydlink setup.  I used my existing account and now all is working.