The Graveyard - Products No Longer Supported > DIR-878
IPv6 and PPPoE (RESOLVED) EU Region Only!
cyrusct82:
I've bought a few days ago DIR-878.
The only problem i have with it is IPv6.
The router gets the IPv6 address from my ISP but it doesn't give access to devices on network.
If i take out the cable from router and connect it directly to my computer, fill in the username and password for PPPoE my IPv6 works good. Here are some screenshots https://drive.google.com/folderview?id=17FbxRjnp7J3590-A134WRNMmu-UQwGyY
FurryNutz:
Link>Welcome!
* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
Internet Service Provider and Modem Configurations
* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
How is the IPv6 settings configured on the router? Auto Detect or other settings in the UI? I would ask your ISP on what IPv6 modes they support on routers and set them accordingly.
Try setting Local Only and then ensure the ULA buttons are enabled then test to see if a PC gets an IPv6 address.
Ensure your PCs and devices have IPv6 enabled as well on them.
cyrusct82:
Please see the pictures in the link.
The settings for IPV6 I've tried everything: Autodetection, PPPoE share with IPV6. Nothing works
FurryNutz:
* What region are you located?
Internet Service Provider and Modem Configurations
* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
What happens if you enable DHCP Always Broadcast and Disable DNS Relay?
cyrusct82:
I'm from Romania.
I have a fiberlink connexion to a Huawei GPON HG8240H.
ISP is DIGI Romania.
Navigation
[0] Message Index
[#] Next page
Go to full version