• November 03, 2024, 11:39:17 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Unable to Setup Repeater  (Read 7517 times)

pracom

  • Level 1 Member
  • *
  • Posts: 2
Unable to Setup Repeater
« on: September 09, 2013, 12:46:05 AM »

Despite following the instructions in the manual, I have been unable to successfully configure the device in the Repeater mode.  I can connect to the device with my PC, which shows Internet connectivity on the taskbar, but I am still unable to connect to any webpage.  Also, while attempting to fix the problem I found that one cannot turn off DHCP and/or change the device IP under Network Settings, at least while in Repeater mode.

Any suggestions on what I should try next? ???
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Unable to Setup Repeater
« Reply #1 on: September 09, 2013, 07:46:55 AM »

Link>Welcome!
  • What Hardware version is your router? Look at sticker under router.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?
  • Has a Factory Reset been performed?

Internet Service Provider and Modem Configurations
  • What ISP Service do you have? Cable or DSL?
  • What ISP Modem Mfr. and model # do you have?
  • What ISP Modem service link speeds UP and Down do you have?

Some features are not supported in Repeater mode.
What Mfr and model # is the main host router?
What wireless modes are you using on the main host router?
Did you use the on-board set up wizard to help you configure the 506L for Repeater mode?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

pracom

  • Level 1 Member
  • *
  • Posts: 2
Re: Unable to Setup Repeater
« Reply #2 on: September 09, 2013, 11:34:23 PM »

Link>Welcome!
What Hardware version is your router? Look at sticker under router.A2
Link>What Firmware version is currently loaded? Found on the routers web page under status.2.13
What region are you located?United States
Has a Factory Reset been performed?Yes - multiple times

Internet Service Provider and Modem Configurations
What ISP Service do you have? Cable or DSL?Cable
What ISP Modem Mfr. and model # do you have?Motorola SB6121
What ISP Modem service link speeds UP and Down do you have?About 6 Mbps down and 1.5 Mbps up

Some features are not supported in Repeater mode.
What Mfr and model # is the main host router?Netgear WNDR3700
What wireless modes are you using on the main host router?WPA-PSK + WPA2-PSK
Did you use the on-board set up wizard to help you configure the 506L for Repeater mode?The set up wizard does not provide a Repeater mode option
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Unable to Setup Repeater
« Reply #3 on: September 13, 2013, 07:17:21 AM »

Well the main web site says it supports repeater functions. It should have options or at least the wizard should have and help you set up the repeater mode.

Can you try a simple test with the main host router and turn OFF WiFi security and then attempt to connect the 506L as a repeater? Will it connect then?

What modes are you using on the Main host router? A, B G and N? Try Single mode G or N or Mixed G and N.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.