Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[batserra]

Hi ,sorry for my english...

I have this router
DSR-1000N
Firmware revision: 1.06B53 (latest)

My problem is that i want to connect this routers, with 2 adsl that i have.
My two routers are with DHCP disabled and their wireless. The dsr it's with dhcp enabled.
My two adsl routers, are connected to wan port.
I try to configure in setup ,internet setup ,wan1/wan2 i try to put in setup information about my router, but never i can access to internet.
All routers are in the same lan ,with static ip.

Does anybody can help me?

Thanks for your answer

[FurryNutz]

Link>Welcome!
What Hardware version is your router? Look at sticker under router.

What ISP Modem make and model do you have?
If this modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems.
Double NAT
To tell if the modem is bridged or not, look at the routers web page, Status/Device Info/Wan Section, if there is a 192.168.0.# address in the WAN IP address field, then the modem is not bridged.
If the modem can't be bridged then see if the modem has a DMZ option and input the IP address the router gets from the modem and put that into the modems DMZ.

For further information, you'll need to contact your regional local D-Link support office regarding the DSR-1000N.

[Vijayakrishna]

Dear,
i have similar issue, I have 2 DSL connections for failover, however couldn’t configure it properly
1)   DSL (A)  on 192.168.0.1/24
2)   DSL(B) on 192.168.2.1/24
Router on 192.168.1.1
What should be ideal settings? pls help

[fperez]

Vijayakrishna,

check this document:

ftp://ftp.dlink.co.uk/dsr/dsr-500n/FAQ/Load_Balancing_setup_in_DSR-series.pdf

Regards.

[FurryNutz]

Any status on this?