• July 18, 2024, 10:35:23 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DIR-895L problem after firmware update  (Read 8194 times)


  • Level 1 Member
  • *
  • Posts: 1
DIR-895L problem after firmware update
« on: October 13, 2019, 10:05:13 AM »

I just bought brannd new DLink DIR-895L router.
When connected to control panel via website and connected to internet I received information that firmawre update is available and should be performed.
I accepted and router was updating, than message came it is updated succefully and than router rebooted.
After that I have a constant orange light blinking and nothing happens.
i tried to reset it to facotry settign by holding reset key for 10 seconds but nothing happens.
Made a ticket to technical support but no asnwer yet.
Dont have phone number to call.
I am from Poland in Europe.
The router specification is as follows:
D-Link DIR-895L
H/W: Ver: A2 F/W Ver: V1.13
S/N: RZYMM2H2000034

Thank You for Your help in advance,


  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DIR-895L problem after firmware update
« Reply #1 on: October 13, 2019, 12:07:04 PM »

I would download the latest FW file from your regional D-Link support office then apply it using this method:
 Emergency Recovery Mode

Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.