• May 20, 2022, 08:36:51 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS-2132L-ES workaround to use it with D-viewcam software free version  (Read 2901 times)


  • Level 1 Member
  • *
  • Posts: 1

Hello after some months searching for an answer about how to see the camera with D-Viewcam free.
This camera hass the https protocol activated and the free version of the D-viewcam does not handle the https protocol so you can not use the camera with this software the port 80 hass been nulified so no access to the regular ip address.
The work around is very simple
modify the port 80 to 8080 save and restart camera
Now configure the free d-viewcam software to look for the camera with the 8080 port
with the user password configured in the camera web interface
Now to access the https port 443 and create the port 80
Download in your smartphone the software "Fing"
after installed go to your network
connect the camera with ethernet cable run the wps in the camera and your router to assign a ip address to the camera
Then open the fing software and run scan for devices look for the DCS-2132l-ES go and click the device
scroll down to se the section to look for open ports, when complete the search for ports wait to complete, then open the 443 port to go to the webpage
your browser will post as not safe go advance and go to the webpage insecured.
then this will open the webpage with the https protocol NOW go to the setup page on the camera and modify the port 80 to 8080 save set up a password and restart.
Now you can configure the d-viewcam software to use the 2132l-ES looking for port 8080 with the user password on the camera