• March 28, 2024, 03:57:24 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DAP-X2810 config page not working properly after firmware upgrade  (Read 4516 times)

guenter@gzoechbauer.com

  • Level 1 Member
  • *
  • Posts: 2

I have a D-Link DAP-X2810 AX1800. I couldn't find a better area to post this question. Please suggest where to post this if this is not the right place.

The device worked fine, but I had issues with DHCP over a range extender, so I looked for a firmware update and found
https://eu.dlink.com/rs/sr/products/dap-x2810-ax1800-wifi-6-dualband-poe-access-point#support
After the update some areas of the config page don't work anymore.

For example
Basic Settings/Wireless only shows an empty page.
The LAN and IPv6 pages look fine.
Advanced Settings/Performance only shows a red "Error:" and the "Save" button.
Advanced Settings/Wireless Resource shows 2 dropdowns with "Enable"/"Disable" to chose from (but no label) and again the "Error" and "Save" button.
Advanced Settings/Multi-SSID shows a loading spinner and again "Error" and "Save" button.
Advanced Settings/VLAN look fine.
The rest looks similar. Some pages look fine, some show partial content.

I tried to uploading the firmware update again and also a factory reset, but no change.

I can still connect to the network using this access point.

Any ideas how to fix the issue or go back to 1.0 firmware?
Logged

guenter@gzoechbauer.com

  • Level 1 Member
  • *
  • Posts: 2
Re: DAP-X2810 config page not working properly after firmware upgrade
« Reply #1 on: May 02, 2022, 04:31:20 AM »

I just came back to my computer and tried again after a few hours and now the config pages seem to work again.
So the issue seems to be solved.
Logged

MathildeBuxton

  • Level 1 Member
  • *
  • Posts: 4
  • Open for everything new
    • sloboda studio
Re: DAP-X2810 config page not working properly after firmware upgrade
« Reply #2 on: May 04, 2022, 04:26:12 AM »

I just came back to my computer and tried again after a few hours and now the config pages seem to work again.
So the issue seems to be solved.
  Great!
Logged
:)