• July 22, 2018, 07:09:08 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Motion detection activated snapshots taking never stops until rebooted  (Read 1528 times)


  • Level 1 Member
  • *
  • Posts: 1

Hello Everybody,

I was wondering if anybody came across and dealt with an issue when after lot's of motion detected camera keeps taking snaps every 30 sec indefinitely until camera is rebooted? it's not specific Firmware, upgraded few times.



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 45309
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology
Re: Motion detection activated snapshots taking never stops until rebooted
« Reply #1 on: September 20, 2016, 12:11:47 PM »


  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

What Mfr and model is the main host router?
How is the camera connected? Wired or Wireless?
What wireless modes are you using?

Haven't seen other users with this issue...
Cable:200mb/10Mb>Motorola MB7420>COVR3902>HP 24pt Gb Switch. 3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,865L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting