The Graveyard - Products No Longer Supported > DGS-1248T

LACP fails between Dlink DGS-1510-52 and Juniper ex2200

(1/1)

anigwei:
Hi,

In other post @PacketTracer user helped me creating a LACP between two identical Dlink Switches.

Now I have the challenge of interconnecing my Stack formed by two Dlink DGS-1510-52 with a Juniper EX2200 with an aggregation Link.

I spend more than 4 hours without success... Neither LACP nor "static aggregation" worked (Theoretically Dlink only support static LAG between Switches, isn't it?).

Simply there is no L3 link... I tried configuring LACP  to be a VLan access port on both ends, and a Trunk, without success.

So... any ideas or hints?

Sincerely: I'm using a too cheap model to do this "advanced" things? My workmate in the other band, which manages the Juniper EX2200, is laughing at me because these things get working in three seconds in Juniper EX2200... which costs the same as Dlink 1510  :-\ :-\ :-\ :-\ :-\


Thanks!!

FurryNutz:
This is something you may want to ask D-Link support about and see if there is a better model out there that supports your needs.
Good Luck.

Navigation

[0] Message Index