D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: northwester on May 07, 2018, 07:47:47 AM
-
Hi guys, I installed the Dlink version A software for the 930l camera but when I type in the internal IP address given to me by Dlink (eg. 192.168.x.x) into the address bar, the page usually won't load. Sometimes it will load and I will see the configuration screen for about 30 seconds before I get a browser message that says "The server at 192.168.x.x is taking too long to respond." I get this in Firefox, Chrome, and Opera. I can't configure my camera :(
Have any of you guys experienced this? If so, any solutions?
Thanks,
Eric
-
Reboot the camera.
Is the link light on the camera solid green?
Can you ping the IP address?
Is the camera connected to a extender?
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your DCS? Look at the sticker behind or under the camera.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DCSs web page under status.
- What region are you located?
What Mfr and model is the main host router?
What wireless modes are you using?
What is the distance between the Camera and the main host router?
Hi guys, I installed the Dlink version A software for the 930l camera but when I type in the internal IP address given to me by Dlink (eg. 192.168.x.x) into the address bar, the page usually won't load. Sometimes it will load and I will see the configuration screen for about 30 seconds before I get a browser message that says "The server at 192.168.x.x is taking too long to respond." I get this in Firefox, Chrome, and Opera. I can't configure my camera :(
Have any of you guys experienced this? If so, any solutions?
Thanks,
Eric