The Graveyard - Products No Longer Supported > DAP-1522
Unable to connect to device via IP address or DLINKAPP
Mike Mills:
I'm reviving this thread as I am having the same problems described in the original post.
I have tried various combinations of static IP addresses for my PC and am 100% unable to log on to the DAP-1522.
All the proper lights are lit and the Bridge light is flashing as it's supposed to be, still I am unable to access the DAP.
EdwinDonald:
--- Quote from: Fred Mertz on September 15, 2010, 06:53:21 PM ---Thanks to your discussion, I was able to get into the DAP1522 setup.
Fred M
--- End quote ---
:-* :-* :-* :-*
__________________________________________________
Nissan shocks andstruts
Toyota quick strut
Toyota shocks and struts
Mike Mills:
So, any ideas as to why I cannot log on to this Bridge?
TCP/IP addresses are proper.
192.168.0.91
255.255.255.0
192.268.0.50
Yellow light is blinking indicating bridge mode.
LAN cable shows connected.
http://192.168.0.50 yields, "Unable to connect,..."
Power light is lit (unit is powered on).
Mike Mills:
I've given up. I went back to Fry's and bought another DAP-1522. I gave it a second try. I also bought a Buffalo NFiniti.
I was able to log on to this second D-Link unit right away. The thing is, I couldn't get it to connect wirelessly. I gave up.
I set up the Buffalo and it worked like a charm. The instructions were written in decent English. They were clear and reasonably thorough (but not great). The software set up went without a hitch. I was able to log on to the device on the first try. It connected wirelessly without a hitch. I'm done.
D-Link, I gave you two chances and you failed me both times. You've lost me as a customer.
bbell123:
Same problem! Tried all the great suggestions but ca not log in to Setup. Tried to reset. Does not seem to go back to factory settings. Is there a more "aggressive" way to reset the unit?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version