D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1360 => Topic started by: philipamd on October 14, 2013, 12:00:34 AM

Title: DAP 1360 setup "this feature has been disabled in this emulator"
Post by: philipamd on October 14, 2013, 12:00:34 AM
Hi,
I just bought DLINK DAP 1360. Want to use it as an Access Point mode.
I have connect it to router, power on, open the wireless setup, then when i pressed the 'Launch Wireless Setup Wizard' button, the "this feature has been disabled in this emulator" came out.

Need help to solve.
Title: Re: DAP 1360 setup "this feature has been disabled in this emulator"
Post by: FurryNutz on October 14, 2013, 07:19:24 AM
Link>Welcome! (http://forums.dlink.com/index.php?topic=41537.0)

Web Browser Configurations
What browser are you using?
Try Opera or FF? If IE 8 or 9, set compatibility mode and test again.
Try turning off these features in Chrome:
Top right corner, little bars for options > Settings > Settings (on left) > Show advanced settings.
Uncheck these:
Use a web service to help resolve navigation errors
Use a prediction service to help complete searches and URLs typed in the address bar
Predict network actions to improve page load performance
Enable phishing and malware protection
Title: Re: DAP 1360 setup "this feature has been disabled in this emulator"
Post by: DennisOlof1 on October 27, 2013, 10:19:07 AM
Have you tried manual config, the wizard is not needed as the configuration is rather simple. And if there are things you do not understand, check the manual.

There are guides there, and also use the internet to learn about the few things you have to configure.

Title: Re: DAP 1360 setup "this feature has been disabled in this emulator"
Post by: FurryNutz on November 09, 2013, 10:52:49 AM
Any status on this?  ???