D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Multimedia and USB => DSM-312 => Topic started by: samhern on December 22, 2012, 09:43:48 PM

Title: DSM-312 Firmware Online Upgrade Problem
Post by: samhern on December 22, 2012, 09:43:48 PM

After powering up the DSM-312 an Online Upgrade window shows up telling a new firmware found Press OK to Continue. (v1.01.23NA). I press OK and it started the process warning to not disconnect power, then it stopped. After a reasonable time passed I had to remove power. So I attempted it again and again, until for no apparent reason it booted into the system menu and I had to re-configure the network. At this time I went into the system menu and asked for an Online Update and it worked....!!!

Title: Re: DSM-312 Firmware Online Upgrade Problem
Post by: JavaLawyer on December 30, 2012, 06:51:11 AM

Did you actually install the upgrade twice, or did the system hang after the first upgrade and then it worked after reboot?

Title: Re: DSM-312 Firmware Online Upgrade Problem
Post by: mrtcop007@hotmail.com on May 22, 2017, 10:12:53 AM

Hi I have a DSM-312 I would like to be explained how to put third party software since I do not like the interface that presents
beforehand thanks

Title: Re: DSM-312 Firmware Online Upgrade Problem
Post by: FurryNutz on May 23, 2017, 10:34:37 AM

You'll have to search the web and see if any 3rd party SW is supported on this mode.

Good Luck.

Title: Re: DSM-312 Firmware Online Upgrade Problem
Post by: mrtcop007@hotmail.com on May 24, 2017, 11:58:44 AM

You have a manual or how to access the ROM files of the DSM-312   ::)

Title: Re: DSM-312 Firmware Online Upgrade Problem
Post by: GreenBay42 on May 24, 2017, 12:36:12 PM

I haven't seen or heard of any 3rd party firmware that would work unfortunately.