D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-1100/1130 => Topic started by: davidl on May 02, 2011, 07:12:15 PM

Title: one minute problem
Post by: davidl on May 02, 2011, 07:12:15 PM

 have the fix for some people. You have to run the microsoft internet connection wizard and make sure that you have UPNP. If you fail the test . it is not going to work. I have a Dir 655 , router with the UPNP. However, the modem was not UPNP capable.

http://www.microsoft.com/windows/using/tools/igd/default.mspx

Title: Re: one minute problem
Post by: TD99 on May 04, 2011, 03:14:20 PM

Nice. Ran it on my environment. Failed the UPnP test, even though my router supports it and it's enabled.

I am thinking that it might have to do with the fact that my router is connected to my Verizon FiOS modem/router and then out to the internet. I have the FiOS device running in "bridge" mode.

Still investigating, when time permits me too...

Will post if any success.

Title: Re: one minute problem
Post by: Tarv on May 04, 2011, 09:56:59 PM

Curious what modem's (model) you guys are using, and what type of connection (dsl, cable, fiber)

Title: Re: one minute problem
Post by: diesel1 on May 05, 2011, 11:58:47 PM

good post

Title: Re: one minute problem
Post by: Colecago on May 28, 2011, 02:14:33 PM

Try setting static addresses for you cams and change their ports, then forward those ports within your router, worked for me, you can't use mydlink anymore, but you can access them via your ipaddress:port

Title: Re: one minute problem
Post by: nickkhun23 on June 01, 2011, 01:49:30 AM

Im new in here, Hope to enjoy this forum.


__________________
Watch Kung Fu Panda 2 Online Free (http://watchonlinefreemovies.biz/)