• April 19, 2024, 02:01:55 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Flashing v2.00KRb09 firmware to Rev.A1 HW  (Read 2282 times)

Inwon

  • Level 1 Member
  • *
  • Posts: 1
Flashing v2.00KRb09 firmware to Rev.A1 HW
« on: September 09, 2015, 12:14:06 AM »

Hi, Members.
I'm using US version 868L Rev.A1 purchase from Newegg. And Using it in Korea Region.
I check the FW at region site and found v2.00KRb09 FW.  So I asked to CS engineer about 'Is it possible to flash recent v2.00 to Rev.A1 HW?
bcoz regional site sells Rev.A1. And he says it's all right to flash it. but hard to reflash to v.1.08 or lower something.
"Even though it's Rev.A1, if flash v.2.00 FW then it'll change to Rev.B ." he said. Ehh???  ???
As I know the recent v2.00 FW is for Rev.b1. HW.  So I'm confusing...
I'm considering to flash it for it has lots of functions like VPN server , VLAN, Repeater Mode, etc...
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Flashing v2.00KRb09 firmware to Rev.A1 HW
« Reply #1 on: September 09, 2015, 07:05:47 AM »

Link>Welcome!

v1.## is for Rev A only routers and v2.## is for Rev B only router. You can't cross them.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.