D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-825L => Topic started by: lor_vader on July 02, 2015, 11:57:02 PM
-
Hi guys,
I've got a problem with my DCS-825L camera. Yesterday I updated the mydlink Baby Camera Monitor and when I tried to connect with te BabyCam, it showed me a message to Update the Firmware. I pressed the OK button and the process finished ok, but the camera showed the PWR LED in solid RED for about 4 hours. I tried to reset the camera using the RST button, but it not respond.
Here you are the camera data if you will help me:
- Hardware Version: A
- Firmware Loaded: 1.0 (before updating the firmware)
Thank you in advance.
Best regards,
Sergio
-
hi sergio
Reset Button Press and hold the recessed button for a minimum of six seconds to reset the camera to the
factory default settings.
if its not working send your camera back.