D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: kencon28 on August 24, 2010, 08:51:30 AM
-
This is one that seems to not be covered. ;) So, hopefully the geniuses here can provide some guidance.
I cannot get my DAP-1522 which is set in bridge mode to communicate with my wireless extender( DAP-1360). The DIR-655 router and the 1360 extender are downstairs. The 1522 is upstairs directly above the extender. I did the "WPS/push button" set up and they are set to G+N. "Static IP" is set on the bridge and extender.
Just in case you'd like to know all the wireless settings, this is what I have and is working:
802.11 Mode: Mixed 802.11n and 802.11g
Enable Auto Channel Scan: CHECKED
Wireless Channel: - CH 11
Transmission Rate: Best (automatic)
Channel Width: Auto 20/40MHz
Visibility Status: Visible
Security Mode: WPA-Personal
WPA Mode: WPA Only
Cipher Type: AES
Group Key Update Interval: 3600
My bridge settings are nothing special, static IP's. I have the default gateway filled in with my DIR-655's IP address, on the other I don't. I also didn't change the advanced Wireless settings in either device, I left Short GI checked.
In case this helps, my advanced wireless settings are:
Transmit Power: High
Beacon Period: 100
RTS Threshold: 2346
Fragmentation Threshold: 2346
STIM Interval: 1
WLAN Partition: UNCHECKED
WMM Enable: CHECKED
Short GI: CHECKED
Extra Wireless Protection: CHECKED
I appreaciate any help or recommendations that you can provide....
-
since you didn't have success in using the wps buttons on the devices, i suggest you configure both devices the old fashion way...