D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: Benn on October 03, 2018, 11:28:55 AM

Title: Blinking red, how do I restore wireless?
Post by: Benn on October 03, 2018, 11:28:55 AM

I have a D-Link DAP-1522 and it is blinking red and the wireless isn't working.
I have gone to 192.168.0.50 and I get the message:
UPDATING FIRMWARE
This page can be used to update the firmware of this device.
Instead of the Web-based Configuration Utility. How do I fix?

Title: Re: Blinking red, how do I restore wireless?
Post by: FurryNutz on October 03, 2018, 11:34:22 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)

• What Hardware version is your DAP? Look at the sticker under the DAP.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DAPs web page under status.
• What region are you located?

Did you power cycle the DAP then try again?
It seems your at a recovery page. Download the FW file to your PC then connect the PC back to the DAP and send the .bin file. Use IE11 or FF browsers with a wire connected PC.

Title: Re: Blinking red, how do I restore wireless?
Post by: Benn on November 14, 2018, 11:56:50 AM

H/W Ver.: B1 F/W Ver.: V2.02
USA
I did try unplugging the power and plugging it back it back but it still does the blinking red light problem.

Title: Re: Blinking red, how do I restore wireless?
Post by: GreenBay42 on November 14, 2018, 12:36:41 PM

Did you try resetting the camera? Hold a paperclip in the reset hole for 10-12 seconds and release. After it reboots you will have to set it up from scratch.