• June 24, 2024, 09:13:28 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Going back to stock firmware on D-Link Dir-300  (Read 11474 times)

Joe96

  • Level 1 Member
  • *
  • Posts: 1
Going back to stock firmware on D-Link Dir-300
« on: August 13, 2014, 10:37:05 AM »

Hey, I have DD-WRT and i tried going back to my original firmware, but i can't. On Firmware Upgrade in DD-WRT, it gives me Upgrade Failed, while using Emergency Room Web Interface, i can't seem to reach it. I followed the instructions, unplugged the router, pressed the reset button, plugged back while pressing, the power led started flashing, i modified my ip settings for 192.168.0.2, and while accessing http://192.168.0.1 with Firefox browser, i get Connection Reset error.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Going back to stock firmware on D-Link Dir-300
« Reply #1 on: August 13, 2014, 10:41:02 AM »

Link>Welcome!

  • What Hardware version is your router? Look at sticker under router.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?

You'll need to refer to the DD-WRT web site for recovery support information.
« Last Edit: August 13, 2014, 11:31:39 AM by FurryNutz »
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.