The Graveyard - Products No Longer Supported > DCS-5020L
DCS-5020L - Firmware Wishlist
JavaLawyer:
--- Quote from: Igodor on December 10, 2013, 10:48:44 PM ---Day / Night Mode Auto setting - Add the ability to customize the sensitivity threshold when switching Day / Night mode.
--- End quote ---
Added... ;)
JavaLawyer:
Below is a summary of everyone's input thus far. Please let me know if I over generalized, misrepresented, or missed anyone's concerns and I'll refresh the list with updates. Recent items are highlighted in blue. Items fixed in the latest firmware update are striked out.
If any items in the wishlist were fixed by the latest firmware, please post and I'll update!
DNS-5020L Wishlist
[*]Audio - Option to configure audio encoding to reduce bit rates and storage requirements
[*]HTTP/HTTPS - Ability to configure HTTPS port (as well as HTTP)
[*]HTTP/HTTPS - Option to explicitly enable HTTP, HTTPS, or both protocols (three options)
[*]Motion Detection - Option to specify number of seconds before motion detection event is included in captured clip
[*]Night Mode - Option to disable IR illuminators
[*]Night Mode - User defined day/night mode transition threshold and sensitivity
[*]Patrol - Option to configure series of preset positions and ability to automatically cycle through preset positions in sequence or randomly (see thread here)
[*]Security - Add three for permission account types with web UI limitations for each: Admin (exists); Monitor (view live feed and point camera); View (view live feed, but not point the camera); and Snapshot (can only access CGI snapshot)
[/list]
Wishlist Items Addressed by D-Link (Thank You!)
[*]TBD
[/list]
AUSUSER:
Not sure if anyone has noticed this, however, I have asked D-Link for their ideas...
Wanted to use the timer feature for overnight.
eg. set timer to motion detect from 6pm until 8am...
This does not appear to work and should be added to the next firmware update
JavaLawyer:
--- Quote from: AUSUSER on December 24, 2013, 01:21:59 PM ---Not sure if anyone has noticed this, however, I have asked D-Link for their ideas...
Wanted to use the timer feature for overnight.
eg. set timer to motion detect from 6pm until 8am...
This does not appear to work and should be added to the next firmware update
--- End quote ---
Motion Detection on a schedule doesn't work for you under SETUP > Motion Detection > MOTION DETECTION SETTINGS > Time?
AUSUSER:
--- Quote from: JavaLawyer on December 27, 2013, 06:10:50 PM ---Motion Detection on a schedule doesn't work for you under SETUP > Motion Detection > MOTION DETECTION SETTINGS > Time?
--- End quote ---
Time Schedule works ok when using times in the same day. ie 8am to 8pm
However, if you try to set the schedule from 6pm to 6am - does not appear to work.
I had trouble explaining this to D-Link support also.
I just want the cameras to detect motion overnight...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version